Refine MaxCure9 Dental LED Curing Lampe Broad-spectrum Curing Light

 

Light cure unit is used for the principle of ray radiation to solidify the light-sensitive resin by shooting at it in a short time, it is used to restore teeth and solidify material for whitening teeth.

 

Used for polymerization of light cure resin-based composites. It can be used on several different dental materials that are curable by light.

 

P1 High intensity mode

Curing time For orthodontic brackets, post and core and curing photosensitive adhesive in porcelain veneer.

High intensity mode

Constant intensity: 2300-2500mw/cm Used for quick curing, ensuring enough curing depth, more efficient

Time setting: 1s. 3s

 

P2 General intensity mode

Curing time For Normal resin.

General mode Constant intensity: 1000-1200mw/cm for most treatment scenarios like teeth filling, restoration etc.

Time setting: 5s, 10s. 15s, 20s

 

Most of the resins on the market use CQ as the photoinitiator, but some resins use two new types of photoinitiators, dipheny phosphorus oxide or Ivocerin, cnd the new materials containing TPO have a light bsorption peak of 405nm. If you use an crdinary narrow-spectrum light curing machine (wavelength range: 420nm-480nm), the resin is prane to incomplete curing. And we know that incomplete composite curing often leads to secondary pulpitis, apical inflammation, and tooth hypersensitivity.

MaxCure 9 broad-spectrum light curing, newly added the 385-420nm band, the wavelength range is 385nm-515nm. It can better cure resin materials containing TPO and other emerging photoinitiators, and is suitable for ideal curing of all resin materials on the market.

After a full upgrade, MaxCure 9 changes from a single blue light to a blue-violet light, which can truly cure all light-curing materials.

 

2600mAh lithiurn battery- International CB certification

MaxCure9 Battery capocity is 85% higher than normal Curing Lights

 

Constant light intensity. Constant light intensity output, stabilizing the working power

 

The main unit will detect the light guide and stop the "Er" flashing if the guide is connected well, or the main unit will close down after 10s flashing.

Well-installed during the period of the error alarm will stop the error alarm and the lamp will light up instantly when the lamp holder is installed.

 

Main unit will detect the temperature. The overheating protection program will run when the curing light reaches a certain temperature after long time use. It' Il keep flashing until 200s later that it recovers from high-temperature.

 

When detect an inconstant power output from battery, the main unit will stop working to warn with flashing "Er".

 

With overvoltage adapter, MaxCure 9 is under protection and can' t be charged. The original adapter is recommended.

 

Humidity 10%-93%

Atmosphere pressure 70kPa-106kPa

Temperature -20°C - + 40°C

Light power more than 2000mw/cm².

3 Distinct Modes: Strong, Flashing, Gradually strong.

2600 mAh Large-capacity lithium battery.

5W Big power LED.

Full charging available use more than 200 times.

Automatic Standby/Automatic shutdown.

 

CHARGING INDICATION:

The light is on when the machine is in charging mode.

 

1 x Light Cure Unit

1 x Adapter

1 x Charging Station

100 x Disposable PE isolation sleeves

1 x Instructions Manual